15
12/2011
By unscrewing the coarse filter, you can remove the filter system.
NOTE:
When following this procedure from step1 to step 2, the filter system will be removed;
when following it from Step 2 to Step 1, the filter system will be installed.
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
REMARK:
The entire filter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a c leaning brush. Reassemble the filter parts as
shown in the figures on the last page and reinsert the entire assembly in the dishwasher, positioning it
in its seat and pressing downwards.
WARNING:
When cleaning the filters, don't knock on them. Otherwise, the filters could be con-
torted and the performance of the dishwasher could be decreased.
Caring for the Dishwasher
The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly. For the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Cleaning the Door
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration o f water into the door lock and electrical components, do not use a spray cleaner
of any kind.
WARNING:
- Never use a spray cleaner to clean the door panel as it may damage the door lock and electrical
components.
- Abrasive agents or some paper towels should not be used because of the risk of scratching or
leaving spots on the stainless steel surface.
Protect against Freezing
Pls. take frost protection measures on the dishwasher in winter. Every time after washing cycles, pls.
operate as follows:
1. Cut off the electrical power to the dishwasher.
2. .Turn off the water supply and disconnect the water inlet pipe from the water valve.
3. Drain the water from the inlet pipe and water valve (use a pan to catch the water).
4. Reconnect the water inlet pipe to the water valve.
5. Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
NOTE:
If your dishwasher cannot work because of the ice, please contact professional service
persons.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will
clog the spray arm jets and bearings.
To remove the upper spray arm, screw off the nut clockwise then remove the
arm.
To remove the lower spray arm, pull out the spray arm upward. Wash the arms
in soapy and warm water and use a soft brush to clean the jets. Replace them
after rinsing them thoroughly.
Step 1: Turn the coarse filter anti-
clockwise and lift it up.
Step 2: Lift the flat filter up.
