BOMANN EHBC 7930, Instruction Manual

Page: 9 / 24

9
Electrical connection
INFORMATION FOR THE AUTHORIZED EXPERT
WARNING:

The installation to the mains supply must conform
to the local standards and regulations.

Connecting the appliance to a domestic power
socket or using multiple sockets or extension ca-
bles is not permitted.

Connect the protective conductor to the locations
marked with .

Improper connection may cause to an electric
shock or fire!

Before connecting, ensure that the power supply
corresponds with the information on the rating la-
bel (door frame) and the wiring diagram.

The appliance is suitable for three-phase and AC
current (220-240/380-420V 3N~ 50/60Hz).

Select the connection type according to the exist-
ing oven connection in the house.

The appliance can be adjusted for single-phase
current by a respective bypass on the terminal
block, based on the circuit diagram below. Select
a suitable cord as mains cable, considering the
connection type and nominal power of the oven.

Fix the mains cable in the tension relief.

The electrical installation of the oven should be
equipped with an emergency switch, which
switches off the whole appliance from the mains
supply in an emergency. The distance between
the contacts of the emergency switch must be at
least 3 mm.

Arrange the mains cable in such a way that it
does not get in contact with any hot components
of the appliance. Do not lead it over sharp edges
or corners.
Connecting the hob to the oven
Insert the plugs at the end of the hob
circuit group H in the appropriate
socket of the oven terminal block O.
Connection plan
Permissible connection methods
CAUTION:
Each connection requires the protective ground of
the mains to be connected to the PE terminal.
NOTE:
L1, L2, L3 = Phase | N = Neutral
PE = Protective ground
220-240V~
50/60Hz
380-420V 2N~
50/60Hz
380-420V 3N~
50/60Hz
H05 VV-F3G
min. 4mm²
H05 VV-F4G
min. 2.5mm²
H05 VV-F5G
min. 2.5mm²
Startup / Operation
Before initial use

Clean the oven interior with all therein located ac-
cessories. Follow the instructions that we give you
in the chapter
"Cleaning and Maintenance".

To burn any manufacturing residue, heat the
closed oven for approx. 30 minutes at 250°C with
-Top/bottom heating-.
NOTE:
The occurring odor and possibly a slight smoke
development cannot be avoided. So, ensure that
the room is well ventilated during the heating pro-
cess.