Bolin Technology SD5SN-M-10162017, User Manual

Page: 10 / 27

10
170 4 7 12 32
180 4 7 11 30
190 4 7 11 28
200 4 6 10 27
NOTE:

Important: Power supply requirement is 24VAC 2.5 Amp to ensure proper functionality of PT motor and
LED illumination. Using power supply lower than 24VAC 2.5Amp will cause camera crashing or
insatiability.
Power Connector: Phoenix Connector Description
1. The anode and the cathode are not distinguished for phoenix connectors of red and black cables.
2. GND: yellow-green color.
Note: GND is used to ground the camera. Ensure that GND is connected to a reliable grounding point.
PoE Power Injector
Other than 24VAC power input, Bolin PTZ camera provides PoE power as an optional power input.
For PoE power, you must use Bolin 80W Power PoE Injector: model BL-PP80. It provides high PoE power up to
the PTZ camera. Connect this PoE injector to a network switch and then run Ethernet cable for data transmission
and power up the PoE PTZ camera (Specific model: EX1000 & SD500 Series) for distance up to 100 meters.
NOTE!

Disconnect the power from the camera before mounting.

Accessories such as the wall mount bracket and the pendant mount bracket may be necessary during mounting.
For their model, refer to the accessory list recommended by your dealer.

The wall bearing capacity and the bracket length must meet all onsite mounting requirements. You will need to
select a mount type based the actual environment.
Mounting the Camera
NOTE!

When mounting the camera, please install the bracket adapter to the bracket first and then mount the camera to
the bracket.

Tighten all the screws to hold the camera securely.

For waterproofing, apply sealant between the dome and the bracket, wall veneer slits, and leading-out holes of the
wall.