Bolin Technology SD5SN-M-10162017, User Manual

Page: 11 / 27

11
Wall Mount
1. Install the wall mount bracket. Get the heads of necessary cable
(Wall cable) through the bracket from the wall outside of the
bracket.
2. Pull the wall cable out through the secure ring.
3. Pull the wall cable out through the adaptor and install the secure
ring and adaptor to the bracket.
4. Connect the camera tail-cable to the wall cable. Insert the cable into the bracket.
5. Install the two screws, insert the camera body head into the adaptor and turn to hang the camera.
6. Lock up the chain-locker from camera body to the secure ring.
7. Screw in the adaptor to lock the camera tight.
This camera can provide SDI video output, IP video output separately and SDI + IP video outputs
simultaneously.
The following sections are the instructions of how to use SDI video output and how to use IP video output.
Use SDI video output
Starting the Camera
After you have mounted the camera properly, connect the camera to power.
Each time the camera is powered on, it will perform a self-test to check the Pan/Tilt/Zoom (PTZ function). After
self-test, you can operate the camera.
NOTE!

The self-test process starts after the camera is powered up. Please wait patiently.

When the operating temperature is lower than zero degrees Celsius, the camera will be automatically pre-heat (the
pre-heat process takes 30 minutes at most). The self-test starts only after the temperature rises above zero degrees
Celsius.
Connect Camera to Monitor/SDI Device
To view your camera, you need to use the coaxial cable to connect your camera to monitor or SDI device.
* The monitor/device must support the signal of HD-SDI or 3G-SDI.
Connect Camera with Controller
To control and configure your camera, you need to connect with control system (or control keyboard) for
communication by RS-485/RS422. Set up the protocol of communication by control keyboard, the camera can auto
detect VISCA and PELCO-D.
1. Connection