Bolin Technology 8 Series, User Manual

Page: 17 / 31

17
BOTTOM DIP SWITCH SETTINGS
The bottom dip switch is for setting the camera configuration for following items:
1. Camera ID Address for RS-485 PELCO protocol
2. Video output / Video color space
3. RS-232 / RS-422/485 selection
4. RS-232 / RS-422/485 baud rate
5. Video resolutions selection
6. IR remote controller ID
Setting of the BOTTOM DIP Switches
Turn off power to the camera before changing the DIP switch settings.
Power on the camera to have the new Dip Switch setting activated.
From the above list, No.1 Camera ID address and NO.2 Video resolution settings can be set in camera OSD menu as
well. The camera takes either the way of OSD menu setting or the way of bottom DIP switch setting. They override each
other. After the camera is turned on, the camera takes the last setting before it is turned on, either set through the OSD or
bottom DIP switch.
The DIP Switch Settings
SW1: Factory Default Setting: ON.OFF.OFF.OFF.OFF.OFF.OFF.ON.
Bit 1~3:
Camera Address setting for VISCA protocol
Bit 4: Video Output/Video Color Space
Bit 5: Reserve
Bit 6: RS-232/RS-422
Bit 7~8: RS-232/RS-422 Baud Rate
1. Camera Address setting for VISCA protocol
B1 B2 B3 Address
ON OFF OFF 1 (Default)
OFF ON OFF 2
ON ON OFF 3
OFF OFF ON 4
ON OFF ON 5
OFF ON ON 6
ON ON ON 7
2. Video Output/Video Color Space
Note: Select the color space which display device supported.
3. RS-232 / RS-422 Setting
B6 RS-232 / RS-422
OFF RS-232
ON RS-422
B4 Color Space Setting
OFF YUV
ON RGB