Bogen Communications
50 Spring Street
Ramsey, NJ 07446
201.934.8500 P.
201.934.9832 F.
www.bogen.com
Web Interface Programming
System Settings Page 2
q
e
u
t
w
r
y
i
q
Input Selection
This drop-down list allows the user to select which input will control the master clock. The choices are:
•
Real Time Clock
•
58 Minute Sync_1
•
National Time_Rauland
•
Wireless Repeater
•
GPS
•
58 Minute Sync_2
•
Dukane Digital
•
RS485
•
SNTP
•
58 Minute Sync_3
•
Rauland Digital
•
59 Minute Sync
•
58 Minute Sync_4
•
Once a Day Pulse
If Once a Day Pulse is selected, then fields for hours, minutes and seconds will appear. Enter the time (in 24 hour mode) that the clock is to
go to when a once a day pulse is present. It must be a minimum of a two second pulse.
w
Backup Selection
This drop-down list allows the user to select a backup input in case of the loss of the primary input. In order to use
the Backup Selection, the following protocols cannot be used as both a primary and secondary input: 59 minute sync, 58 minute 1-4 sync,
National Time/Rauland, Dukane Digital, Rauland Digital and once a day Pulse. An example of a configuration would be SNTP being the
primary input and 58 minute correction being a secondary input. Setting the primary source to 59 minute sync and the secondary source to
Dukane digital would be an incorrect configuration.
e
Clock #1 Circuit
This drop-down list allows the user to select the sync-wire output for the Clock #1 circuit. The choices are:
•
59 Minute Sync*
•
58 Minute Sync_3*
•
National Time_Rauland 2*
•
58 Minute Sync_1*
•
58 Minute Sync_4*
•
Once a Day Pulse
•
58 Minute Sync_2*
•
National Time_Rauland_1*
•
Rauland Digital
r
Clock #2 Circuit
This drop-down list allows the user to select the sync-wire output for the Clock #2 circuit. See #3 above for the list of
choices.
t
Reset All Setting to Default
This button, when pressed, will revert all settings back to the default settings that were sent from the
factory.
y
Submit
This button, when pressed, will save all of the information to the master clock.
u
Cancel
This button, when pressed, will clear out any changes made and will not save any data.
i
Menu
This button, when pressed, will bring the user back to the main menu.
* See page 24 for protocol definitions
