Boge airtelligence PROVIS, Operating Instructions Manual

Page: 9 / 53

Allgemein.pm6.5 - GB
Page 1.3
General
BOGE Operating instructions for airtelligence PROVIS
1.2.1
Correct use
This BOGE multiple system control including its options is intended for the
control of several screw and piston compressors.
It may only be operated and adjusted by trained and authorised people.
Requirements for compressors to be controlled
If the master control is ordered with compressors, we install the interface in
the compressors in the factory (forced option). If the compressors are already
installed, it will be necessary to meet the requirements for the master control.
These are normally:
1. A potential-free contact "Ready" (2 terminals)
2. Two terminals in series with the pressure switch installed in the compres-
sor.
3. A potential-free contact "Operation" (2 terminals).
4. A potential-free contact "Fault" (2 terminals).
For compressors with proportional control or frequency control please
contact BOGE.
Care must be taken with other makes; always obtain approval from the
factory.
This BOGE control is not explosion protected.
Do not operate in explosive areas!
The following is not permitted:
– Exceeding or going below the specified operating voltages
– Operation of the control by unauthorized or untrained persons
– Connection of unsuitable compressors
– Too high room temperatures > 45°C
1.2.2
Inadmissible use
Introduction 1.2