Boge airtelligence PROVIS, Operating Instructions Manual

Page: 11 / 53

Allgemein.pm6.5 - GB
Page 1.5
General
BOGE Operating instructions for airtelligence PROVIS
1.3.1
Installation and
adjustment
– The electronic pressure sensor must always be fitted verticaly (plug
upwards) on the common receiver or pipelines and free of condensate
water.
– If the air is damp (eg, system without dryer), it will be necessary to verti-
cally install between the muff and pressure sensor a 150 mm pipe.
– The cutout point of the pressure switches of the individual compressors
must be set at least 0.2 bar higher that the upper cutout point of the master
control.
Attention!
The maximum operating pressure of the individual compressors may not be
exceeded.
– The pressure switches of the compressors are only used to allow opera-
tion in the event the master control fails.
Attention!
In the adjustment sequence the sub-menu "Pressure thresholds" must first
be checked and adjusted; thereafter the sub-menus general parameters;
"Compressor data" must be adjusted in this order.
– These operating instructions are only valid in conjunction with the appro-
priate circuit diagram.
– Instructions for making adjustments are given in the individual chapters.
Commissioning, adjustment, troubleshoorting and repairs may only be
performed by qualified electricians (see DIN VDE 0100, DIN VDE 0113 and
DIN VDE 105).
Product description 1.3