Bodyworx JSPORT3000, Owner'S Manual

Page: 28 / 30

28
D15 Round head hex bolt M8X40
2
D45 Cross washer bolt M5X15
5
D16 Round head hex bolt M8X45
1 D46 Cross washer bolt M5X20 2
D18 Nylon Nut M10
3
D48 Cross head self taping bolt
ST4.2X19
12
D22
Nylon Nut M8
8 D50
Cross head self taping bolt
ST4.2X25
2
D21
Flat washer M10
17 D51
Cross bolt M5X8 6
D23
Flat washer M8
19 D52 Cross head self taping bolt
ST4.2X16
31
D24
Spring washer M5
2 D57 Cross head self taping bolt
ST4.2X25
4
D25
Spring washer M8
4 D58 Cross head self taping bolt
ST3.5X16
2
D26
Washer
6 D62
Incline shaft cover 2
Fault Code Fault Description Fault Processing
E1
Communication abnormal: The
control and computer has
abnormal communication after
start
The controller is not working and going into fault. The machine can
not run, the computer shows fault code “E1”, and the buzzle will
ring three times.
Possible Reasons: Communication obstructed between controller
and computer, please check the wire and make sure the wire
connect well and the wire without any damager..
E2
No Speed Wireless Sensor
Network: Can’t receive the
motor speed sensor feedback
above three seconds.
Stop and go into fault status, computer buzzle will ring 3 tones and
shows fault code“E2”. Other areas show blank. After 10 seconds
will go into ready mode, and can restart.
Possible Reasons
：
Can’t receive the motor speed sensor
feedback above three seconds, please check sensor plug and
motor connect wire and the controller.
E3
The motor wire is not
connecting well
Stop and go into fault status, computer buzzle will ring 3 tones
and shows fault code“E3”. Other areas show blank. After 10
seconds will go into ready mode, and can restart.
Possible Reasons
：
Check if the motor wire is connected well and
re-connect the motor wire well if not; check if the controller has the
smell and change the controller if have
Error code and significance