STEP 7
Attach the Seat Back (40) to the Seat Carriage (35)
with four M8 x 40mm Screws (62) and four
M8 x 20mm Washers (54).
Connect the Rear Extension Wire (46) to the Pulse
Wire (5).
ASSEMBLY INSTRUCTIONS
BDEX2496.0
STEP 8
Have a second person hold the Handlebar Upright (4)
in the position shown. See the inset drawing. Connect
the Upper Wire (80) to the Reed Switch Wire (25).
Connect the Handlebar Upright Wire (24) to the Front
Extension Wire (49).
See the inset drawing. Connect the Resistance
Control Cable (9) to the plastic connector on the
Lower Resistance Control Cable (10) in the following
way:
• Insert the end of the Resistance Control Cable (9)
through the connector as shown. Next, press the
small cylinder on the end of the Resistance Control
Cable into the hole in the connector.
• Pull the Resistance Control Cable (9) upward and
insert it into the hole in the top of the connector.
• Remove the metal clip (not shown) from the bottom
of the connector.
Slide the Handlebar Upright (4) onto the Frame (13).
Be careful to avoid pinching the wires and the
cables. Attach the Handlebar Upright (4) with four
M8 x 12mm Screws (51) and four M8 x 20mm Curved
Washers (52).
PLEASE DO NOT RETURN TO STORE; CALL OUR CUSTOMER SERVICE DEPARTMENT FIRST AT
1-877-872-6970
10
62
46
40
35
54
5
51
51
80
24
49
25
10
13
9
52
52
4
49
24
80
9
10
25
