Body Solid G1S, Assembly Instructions Manual

Page: 8 / 31

A. Attach Low Pulley Bracket (K) to Foot Brace (L) using:
One 50 (1/2” nylon lock nut)
Note:
Wrench tighten the Nylon Lock Nut (50), but do not over-tighten. Over-tightening will
restrict the Low Pulley Bracket (K) range of motion.
B. Attach Foot Brace (L) to Main Frame (A) using:
Two 42 (3/8” x 2 3/4” hex head bolt)
Four 53 (3/8” flat washer)
Two 52 (3/8”nylon lock nut)
Note:
Foot Brace (L) goes onto the right side of the gym (standing in front, facing the gym).
Make sure holes for the weight stack are on the opposite side (left side).
C. Attach Seat Extension Frame (M) and 2”x5” Plate (N) to Angled Support Pillar (E) using:
Two 41 (3/8” x 3” hex head bolt)
Two 52 (3/8” nylon lock nut)
D. Attach bottom of Seat Extension Frame (M) to Main Base Frame (A) using:
One 42 (3/8” x 2 3/4” hex head bolt)
One 52 (3/8” nylon lock nut)
E. Attach 2 Convex End Caps (5) and Grip Tape (15) to Foot Brace (L) as shown.
Attach 1 Convex End Cap (6) and Rubber Pad (27) to Seat Extension Frame (M) as shown.
Make sure Rubber Stop (35) and Jam Nut (34) is pre-installed into Seat Extension Frame (M).
4
Be careful to assemble all components
in the sequence they are presented.
mm
Inch
8
Note:
Finger tighten all hardware in this step (except where noted in step 4A).
S T E P