Body Solid G1S, Assembly Instructions Manual

Page: 2 / 31

1
Be careful to assemble all components
in the sequence they are presented.
A. Attach Main Base Frame (A) to Rear Base Frame (B) using:
Two 46 (3/8” x 2 3/4” carriage bolts)
Two 53 (3/8” flat washer)
Two 52 (3/8” nylon lock nut)
B. Attach 2 Foot Caps (9) to Rear Base Frame (B) as shown.
C. Attach Vertical Support Pillar (D) and Flat Plate (10) to Main Base Frame (A) using:
Two 42 (3/8” x 2 3/4” hex head bolt)
Four 53 (3/8” flat washer)
Two 52 (3/8” nylon lock nut)
D. Attach Angled Support Pillar (E) to Main Base Frame (A) using:
Two 42 (3/8” x 2 3/4” hex head bolt)
Four 53 (3/8” flat washer)
Two 52 (3/8” nylon lock nut)
E. Attach Convex End Cap (3) to the front of the Main Base Frame (A).
Attach Convex End Cap (3) to the top of the short pillar on top of the Main Base Frame (A).
Attach Rubber Stop (35) with Jam Nut (34) to the short pillar on the Main Base Frame (A)
as shown.
mm
Inch
2
NOTE:
Finger tighten all hardware in this step. Do Not wrench tighten until end of step 6.
S T E P