Body Solid G1S, Assembly Instructions Manual

Page: 10 / 31

5
Be careful to assemble all components
in the sequence they are presented.
A. Put Foam Roller Bar (H) through Leg Frame (P) and attach 2 Foam Rollers (18) with
3” Plastic Washer (26) on the inside and 1” Roller End Cap (8) on the outside as shown.
Note:
There are two possible holes to mount Foam Roller Bar (H) to Leg Frame (P). If the
main user of this gym is 6’ tall (or more) mount in the lower opening, for shorter
people (under 6’) mount in the top opening. This piece is not inter-changeable,
once these pads are installed they are permanent.
B. Attach Leg Frame (P) to Seat Extension Frame (M) using:
One 40 (1/2” x 3 1/4” hex head bolt)
Two 56 (1/2” round end cap washer)
One 50 (1/2” nylon lock nut)
Two 21 (1/2” bolt cover)
Note:
Wrench tighten bolt (40) only. Leave all other bolts finger tight.
Round End Cap Washers (56) hold Bolt Caps (21) in place.
C. Put Foam Roller Bar (H) through Seat Frame (Q) and attach 2 Foam Rollers (18) with
3” Plastic Washer (26) on the inside and 1” Roller End Cap (8) on the outside as shown.
D. Put two Convex End Caps (3) into the top and bottom of Leg Frame (P). Put 1 3/4” x 1 3/4”
End Cap (7) into the bottom of Seat Frame (Q). Slide Seat Frame (Q) into Seat Extension
Frame (M), hold in place with Threaded Pop Pin (60). Attach two Convex End Caps (6) to the
front and back of Seat Frame (Q) as shown.
mm
Inch
10
Note:
Finger tighten all hardware in this step (except where noted in step 5B).
S T E P