ASSEMBLY- STEP 6
**Note
:
Do Not fully tighten pulley bolts and nuts until after cable routing
The following Parts and Hardware will be needed to complete Step 6
Parts Description
Qty Part Part
Description
1 U
Lat
Bar
1
N
Welded Adjustable Double Bracket
2 A5
3/8
"
×
1
3/4
"
hex head bolt
2 B2
3/8
"
nylon lock nut
1
D10
Spring snap link
2 D14
4
¼
"
pulley
1
D21
lat / stack cable 3235mm
2
D30
Round end cap
Step by Step
1. Begin routing cable (D21) from the housing where the (U) - Lat Bar hangs
2. Route cable over the top of (D) - Top Frame, down through
3. (N) - Welded Adjustable Double Bracket and back up and over (I) - Top Weight Stack
Frame as shown
4. When connecting screw end of (D21) - Cable to (D18) - Selector Shaft, ensure that the
screw is threaded a minimum of 1/2
"
.
Page 17
EXM-1500G ASSEMBLY INSTRUCTIONS
EXM1500G-112003