BRB835/852/880
Page 9
Remove the two Bolts
(#32)
and two Arc Washers
(#33)
that are pre-assembled on the Front Post
(#02)
and set
them aside nearby.
Attach the Front Handle Bar
(#10)
to the Front Post
(#02)
as illustrated by inserting two Bolts
(#32)
through two Arc
Washers
(#33)
in through the Front Post
(#02)
.
Remove the two Screws
(#31)
that are
pre-assembled
on the back of the Monitor
(#11)
. Set them aside nearby
as they will be used later in this step.
With the help of an assistant, connect the Monitor Wire 1
(#25)
to the corresponding wire
(11b)
of the Monitor
(#11)
.
Connect the Hand Pulse Wire 3
(#24)
to the
corresponding wires
(11a)
of the Monitor
(#11)
as illustrated.
Being careful not to pinch/damage any of the wires, tuck
in the connected wires through the mouth of Front Post
(#02)
and attach the Monitor
(#11)
to the bracket on the
Front Post
(#02)
by using the previously removed two
Screws (
#31)
.
Step 6
FRONT HANDLEBAR ASSEMBLY
MONITOR ASSEMBLY
Hardware Required
Assembly Instructions
#33
Arc Washer (M8)
Pre-assembled
[2 pieces]
#31
Screw (M5x10mm)
Pre-assembled
[2 pieces]
#32
Bolt (M8x15 mm)
Pre-assembled
[2 pieces]
NOTE :
INCREASE /DECREASE TENSION
To increase the tension (+ higher level of intensity), turn the
Tension Control (#28) in a clockwise direction.
To decrease the tension (- lower level of intensity),
turn the Tension Control (#28) in a counter-clockwise
direction.
“1” is the lowest level of tension (easiest level for workout);
workout).
THE ASSEMBLY PROCESS IS NOW COMPLETE.
However, for your own safety, please make sure to read this entire Owner’s Manual which includes
For your safety , please visually and functionally inspect and test the unit after assembly is complete.
31
11
25
24
02
11b
11a
10
02
33
32
24
25
11a
11b