Bodum Bibo Bar, User Manual

Page: 13 / 16

bibo brighter water 13
Installation
Safety tips:
• Remember your BIBO Bar weighs 14kgs so take care when lifting it from its box.
• Install your BIBO Bar in a cool, dry place where it is well ventilated. It must be kept away from any heat source.
• Keep the rear of your BIBO Bar at least 5cm (2”) away from the wall.
• The water pressure should be between 1bar (14.5psi) and 6bar (87psi)
• Your BIBO Bar needs a normal 13amp power supply.
1. Carefully remove the packaging and place your BIBO Bar in its preferred location on the work surface.
2. Remove the plastic bag and protective covering from the cable and plug.
3. Remove the drip tray wrapping.
4. Remove the blue locking clip from the inlet water fitting on the back of your BIBO Bar, depress the ‘collar’ on the fitting
then remove the blanking plug (see the pictures on page 11 of this manual for guidance).
5. Push the right angle water fitting (supplied with the BIBO self-installation kit) into the water inlet then replace the blue
locking clip.
Setting Up
Safety tip: Make sure both power switches on the back of your BIBO Bar are in the off (‘o’) position before connecting to
the power supply (see the illustration on page 4 of this manual for guidance).
Now follow the instructions called “Using Your BIBO Bar” on pages 6-8 of this manual.
PLEASE ENSURE THAT YOU DO NOT TURN THE BIBO BAR’S HOT TANK SWITCH ON (THIS IS ON THE BACK
OF UNIT, CLEARLY LABELLED) UNTIL YOUR BIBO HAS FILLED ITSELF WITH WATER.
If you have any questions please call us: 0800 678 5969