Bodum Bibo Bar, User Manual

Page: 11 / 16

bibo brighter water 11
Water supply connection
• The water pressure should be between 1bar (14.5psi) and 6bar (87psi)
• Remove the clear locking clip from the inlet water fitting, if fitted. (Picture 1)
• Depress the collar then remove the clear plastic blanking plug, if fitted (Picture 1)
• Insert the water pipe (Picture 2)
• Replace the blue locking clip (Picture 3)
(Picture 1) (Picture 2) (Picture 3)
Troubleshooting
If a fault should occur, please first use the troubleshooting guide below to determine the fault type, and then follow the
steps listed to resolve the issue. This should help you resolve the fault with the minimum effort.
If you find that your BIBO Bar is not working properly, or if the problem persists, your BIBO Bar may need to be
professionally repaired. Please contact us at
customers@bibowater.co.uk or call
0800 678 5969
to speak to one of our
team.
FAULT POSSIBLE CAUSE SOLUTION
No water
flow
1. Not connected to power supply
2. Power socket failure
3. Water inlet tap closed
4. Water supply blockage or low water pressure
1. Unplug the machine and then plug it back in
again, check switch is on
2. Check the socket and fuse
3. Check that the water inlet tap is open. Check
your water supply and pressure
No hot
water
1. Hot tank is not turned on
2. Excessive hot water use
3. The machine was in power saving mode
1. Turn on the hot tank switch at the back
2. Test again after 5 minutes
3. Wait for the hot tank to reach maximum
temperature
No cold
water
1. Excessive cold water use
2. If unused for an extended period, ice can build
up in the, cold water tank
1. Test again after 25 minutes
2. Turn off the power and wait 2 hours before
turning it back on
BIBO leaking
1. Drip tray is full and overflowing
2. Leak inside the BIBO
1. Empty the drip tray and dry thoroughly before
replacing
2. Turn off the power and water, please contact
BIBO Technical Support
Odour from
the water
1. New machine
2. The machine has not been used for a long period
3. The filter has not been replaced when necessary
1. Drain 2L of water from each tank
2. Replace the MAXI filter cartridge
3. Replace the MAXI filter cartridge