12
Boca’s Family of Ethernet Products
b. If attaching to “thin coax” cable:
1. Attach a BNC T-connector to the BNC port on the
board. Align the notches on the card’s BNC connector
with those on the T-connector. Twist clockwise
approximately one-quarter turn.
2. Is the workstation at the end of the cable segment?
If NO
, attach the BNC connector on the cable from each
adjacent workstation to the two open ends of the T-
connector as shown below.
If YES
, attach a terminator to the open end of the T-
connector as shown below:
12
12
12
12
12
12
Network
cable to
adjacent
workstation
BNC
T-connector
12
12
12
12
12
12
12
12
Network
cable to
adjacent
workstation
BNC
T-connector
50-ohm BNC
Terminator
