15
b. If 10Base2, attach the special plug end of the supplied dual-
purpose cable to the Boca card. Connect the BNC end to a
BNC T-connector. Twist clockwise approximately one-quarter
turn. NOTE: If the workstation (i.e., your laptop), is at the
end of the
cable segment, you will need to attach a 50-ohm
terminator to the open end of the T-connector.
STEP 3: Install the Drivers
There is a driver diskette included with the BOCALANcard-PC.
This diskette configures the card to the type of software in your
system. Before beginning installation, make a back-up diskette for
the software driver diskettes. Use the backup diskette as the
working diskette. If drivers do not appear to have installed
correctly, or if your receive an error message, refer to Section Three:
Troubleshooting.
An install program is provided to install the BENCFG utility and
the other drivers onto your hard disk. To run the program, insert
the Boca driver diskette, type A:\INSTALL.
Please read the introductory screen which provides some
cautionary notes before beginning actual driver installation. Press
any key when done. The BOCALANcard-PC Install Program
provides a series of options as follows. Continue with the next
page for a discussion of these options.
Installation and Configuration
