Page 3
Replace Cover
Check Dryer Operation
Maintenance
Warranty
1. Replace cover by positioning the top retaining bracket at top rear
edge of cover, behind the back of mounting base. Tilt cover
downwards and over flange on air inlet/outlet grille. Ensure that the
rubber
strip is in place between the cover and the grille.
NOTE:
Space between cover and wall must be the same on both sides.
2. Tighten the single cover-locking screw located in recess in the air
inlet/outlet grille.
1. Turn electrical supply on. Position hands under air-outlet opening and
dryer should turn on. Remove hands from under air-outlet opening
and dryer should stop.
WARNING:
1. TURN ELECTRICAL SUPPLY OFF BEFORE DOING ANY MAINTENANCE OR SERVICE TO DRYER.
2. DRYER MUST NOT BE OPERATED UNLESS COVER IS IN PLACE.
3. MOTOR LAMINATIONS ARE LIVE.
1. Exterior of cover should be cleaned with a damp cloth to remove dust and surface dirt. Do not use abrasive agents or solvents as they may
permanently damage surface of cover.
2. At least once every 6 months remove cover. Using a small brush or vacuum, clean out build up of dust and lint from air inlet/outlet grille.
NOTE:
If dryer is installed where there is a lot of dust and dirt in the air, the interior of the dryer should be cleaned out more frequently.
IMPORTANT LIMITED
WARRANTY
SAVE
Installation Date: _____________________________________________________________________________________________________________
Serial No(s).: _________________________________________________________________________________________________________________
Installation Address:___________________________________________________________________________________________________________
Telephone No.: _______________________________________________________________________________________________________________
The Bobrick Dryer(s) of the serial number(s) indicated herein, and all parts (except motor brushes) are warranted to the original owner of the installed unit for ten
years from date of original purchase, against defects in factory workmanship or material under normal use and service.
*
Motor brushes shall be warranted for three years from date of purchase. This warranty is limited to repair or exchange of defective parts at the option of Bobrick
Washroom Equipment, Inc.
THIS WARRANTY DOES NOT COVER ACCIDENTAL DAMAGE, IMPROPER HANDLING OR INSTALLATION, OR REPAIRS MADE BY UNAUTHORIZED
PERSONS, AND SPECIFICALLY EXCLUDES CLAIMS FOR INDIRECT, ACCIDENTAL OR CONSEQUENTIAL DAMAGES TO PROPERTY. THE IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED TO THE SAME DURATION OF THE ABOVE WARRANTY.
Some states do not allow the exclusion of incidental or consequential damages, so the above limitation or exclusion may not apply to you. Some states do not allow
limitations on how long an implied warranty lasts, so the above limitation may not apply to you. This warranty gives you specific legal rights, and you may also have
other rights which vary from state to state.
*
Normal service constitutes performing the following preventative maintenance procedures at six-month intervals.
A. Remove cover and clean any lint, dust or grease from air inlet/outlet grille.
B. Visually inspect motor brushes to ensure remaining brush length is a minimum of 1/2-inch (13mm).
Labor costs for preventative maintenance shall be at owner’s expense.
For repair or exchange of defective part, send the part, together with installation date and serial number, to BOBRICK.
