28
SPEKTRUM DX6e • TRANSMITTER INSTRUCTION MANUAL
EN
FUNCTION LIST
V-Tail Differential
Only available in Sailplane Type when V-Tail A or V-Tail B is active. See
SAIL
(Sailplane) section for set up.
Camber Preset
Only available in Sailplane Type when a 2 aileron wing type is selected. See
SAIL
(Sailplane) section for set up.
Camber System
Only available in Sailplane Type when a 2 aileron wing type is selected. See
SAIL
(Sailplane) section for set up.
Flap System
Only available in Airplane Type when a fl ap-enabled wing type is selected. See
ACRO
(Airplane) section for set up.
Pitch Curve
Only available in Helicopter Type. See
HELI
(Helicopter) section for set up.
Swashplate
Only available in Helicopter Type. See
HELI
(Helicopter) section for set up.
Gyro
Only available in Helicopter Type. See
HELI
(Helicopter) section for set up.
Tail Curve
Only available in Helicopter Type. See
HELI
(Helicopter) section for set up.
The following menu options are only available when they are enabled from the Model Type screen.
Mixing
Mixing allows control input for a channel to affect more than one
channel at a time. Mixing functions support:
• Mixing a channel to another channel.
• Mixing a channel to itself.
• Assigning offset to a channel.
• Linking primary to secondary trim.
These mixes are available for each model memory:
Select a channel for master and slave. Inputs for the
master channel control both the master and slave channels. For
example, Elevator to Flap makes elevator the master channel and
fl ap the slave channel.
Offset
Change the Offset value to move the effective center position
of the slave channel. Positive or negative value determines the
direction of the offset. Offset is not available for curve mixes.
Trim
If the master channel trim should also adjust the slave channel,
set Trim to Act. A channel monitor on the left side of the screen
shows how channels respond to input. To view a switch-assigned
mix on the monitor, the mix switch must be in the active position.
• 5 programmable mixes
• Cyclic to Throttle (HELI)
• Swashplate (HELI)
• Elevator to Flap (ACRO)
• Aileron to Rudder (ACRO)
• Rudder to Aileron/Elevator (ACRO).
• Aileron>Rudder (SAIL)
• Aileron>Flap (SAIL)
• Elevator>Flap (SAIL)
• Flap>Elevator (SAIL)
Assigning a Mix to a Switch
If you wish to assign a mix to a switch position:
1. Make sure you are in the desired mix screen.
2. Move the switch you want to assign the mix to.
3. Scroll to the switch position where you want the mix to be
active.
4. Press the scroll wheel to activate the mix. When the box is
fi lled, the mix is active.
The mix is Active when the box is fi lled and Inactive when the
box is open. You can assign a mix to be active in multiple switch
positions (0,1 or 2).
Tip:
Use Auto Switch Select to select the switch.
CAUTION:
Always do a Control Test of your model after
changing mixes.
