5
5. Using the BLOKS. remote 14d
5.1 Switching on and off, screen explanation
Turning the system on:
The system as a whole consists of the remote and the pedelec. To turn on the system, press either the “Power” button on the BLOKS.
remote 14d or the button on the battery (varies depending on the model). The display screen will turn on after a few seconds.
The next picture [Fig. 8, page 6] shows all segments of the display at once. While riding, the display will not actually show all segments at
the same time – it will look more like the screen above [Fig. 7]. In the example above, you are riding with the third support level at a speed
of 27 km/h. The battery is not entirely full, but well charged, and you have covered a distance of 65.3 kilometers on this trip.
Turning the system off:
To turn off the system, press either the “Power” button on the BLOKS. remote or the button on the pedelec’s battery (varies depending on
the model). The display and your pedelec will be turned off.
Automatic switch-off:
If your pedelec is not used for several minutes, the system will be switched off automatically. Pressing the “Power” button again switches
the system on again.
4. Overview of rocker switch and buttons
The entire display of the BLOKS. remote 14d forms a rocker switch. The display can be
pressed at the top for the "+" function and at the bottom for the "-" function. In addition,
there are three buttons for "Power", "Light" and "Set" [Fig. 7]. The rocker switch and the
buttons have the following functions:
"Power"
=
Switches display / pedelec* on or off
"+"
=
Motor support is increased one level
"+" press and hold
=
Walk assist is turned on
"-"
=
Motor support is decreased one level
"-" long press
=
Trip is reset to 0
"Light"
=
Switches lighting on or off
"Set"
=
Changes the selection in the display
"Set" long press
=
Changes units between metric and imperial
*depends on pedelec model, see chapter 5.1 below
Caution: Carefully press the two ends of the plug together [Fig. 6]. If
the two ends are not correctly aligned, the plug could be damaged.
When disconnecting or connecting the plug, make sure only to hold
the ends of the plug, not the cable itself. When connecting the plug,
do not bend the cable to avoid kinking and damaging it.
[Fig. 6] Carefully press plug together
[Fig. 7] Rocker switch and buttons
