6
5.2 Display
The BLOKS. remote 14d has an LCD (Liquid Crystal Display). The different segments show:
1. Distance or range (see chapter 5.5)
2. Trip (TRP), Range (R) or Odometer (T) (chapter 5.5)
3. Support level (chapter 5.7)
4. Speed (chapter 5.8)
5. mph = Miles per hour, unit of measurement (chapter 5.6)
6. km/h = Kilometers per hour, unit of measurement (chapter 5.6)
7. Battery level (chapter 5.9)
Note: In Figure 8, all segments of the display are shown. While riding, a typical display
screen does not show all segments at the same time.
Warning: Never let the display distract you so much that you lose
awareness of your surroundings. In the worst case, such a distraction
could lead to serious injury or death.
5.3 Lighting
Press the "Light" button (chapter 4, page 5) to turn on the lighting. Normally, lighting on the pedelec consists of a front and a rear light.
While there is no visual representation of lighting on the LCD display, the backlight of the remote 14d will turn on and remain on as long as
the lighting is on. Press the light button again to turn off the lighting.
5.4 Walk assist
Press and hold "+" on the rocker switch (chapter 4) to turn on the walk assist function. Walk assist turns on the motor to slowly (6 km/h)
propel your pedelec forward without any pedaling from the rider. This function can be handy, for instance, when pushing the pedelec up a
ramp. There is no visual representation of walk assist on the LCD display; the function ceases as soon as "+" is released. If you start pedaling
or go faster than 6 km/h, the walk assist function will also cease.
5.5 Trip, range and odometer
At the top right [Fig. 8, number 2], the display indicates whether it is showing the trip distance (TRP), the estimated remaining range of the
pedelec (R), or the odometer = the total distance the pedelec has travelled (T). The default setting for the display is TRP = trip distance. Long
pressing the "-" button (chapter 4) will reset the trip counter TRP to 0.
To change the display settings, press the "Set" button (chapter 4) once to show R = range or twice to show T = odometer. Pressing the "Set"
button again will continue to cycle the display through the sequence TRP / R / T; after T the display returns to TRP.
The display shows up to 9999 kilometers or 6213 miles. If the odometer reaches more than 9999 kilometers, it rolls over to 0 kilometers.
5.6 Units
Long press the "Set" button (chapter 4) to change between metric units of measurement (km/h = kilometers per hour) and imperial units of
measurement (mph = miles per hour). The units are shown in Fig. 8 above as numbers 5 and 6.
[Fig. 8] LCD display
