Retrofit/Installation Kit no. 82 44 0 007 417 Date: 0
3
.2001
Installation Instructions no. 01 29 0 138 198
5.
Install supplementary wiring harness
F 53 0151 EVA
1
2
3
4
5
J
F 53 0152 EVA
+
1
G
E
Pull off the upper black connector
X12
(1) of the
light check module and select the cable of cable
colour white/blue (pin 13). Unpin this cable with
the aid of an unpinning tool.
Plug in the cable, cable colour white/blue,
coming from branch cable
J
, into connector
X12
(1) of the light check module (pin 13).
Plug the 1-pole socket housing (3) on to the
contact socket of the white/blue cable (4) and
connect with the pin housing
X343S
(5) of
branch cable
J
.
Fasten branch cable
G X1209
, green relay, and
branch cable
E X1856
, black relay, with cable
ties at a suitable place behind the joint
connector box (1).
EN/10
Make sure there is good earth contact, poor
earth contact will impair function!
Install branch cables
K
, cable colour red, and
L
,
cable colour brown, each of cable cross-section
2.5 mm
2
, along the right sill strip as far as the
rear of the rear seat bench.
Install branch cable
L
, cable colour brown, along
the series wiring harness (1) to the earth pin
X10012
(2) and connect it .Tie back branch
cable
L
and fasten with cable ties.
F 53 0170 EVA
1
2
L
F 53 0144 EVA
K
1
2
3
Install branch cable
K
, cable colour red, along
the main wiring harness to the power distribution
box
X3245
(1) on the left-hand side of the
vehicle in the spare wheel recess. Connect the
ring terminal (2) coming from branch cable
K
to
the power distribution box B+
X3245
(1).Tie back
branch cable
K
and fasten with cable ties to the
main wiring harness. Fasten the fuse holder (3)
with cable ties to the main wiring harness.