Retrofit/Installation Kit no. 82 44 0 007 417 Date: 0
3
.2001
Installation Instructions no. 01 29 0 138 198
Undo the Torx screws (1) over the whole roof
railing (3 Torx screws on each side) (2) and lift the
roof railing (2) off.
5.
Install supplementary wiring harness
F 53 0143 EVA
2
1
F 53 0155 EVA
280mm
30mm
1
2
3
4
Ø10 mm
F 53 0168 EVA
M4
M1
M2
M3
2
1
q
Care should be taken to see that the roof
outer skin panel (1) and the two reinforcement
plates lying underneath (2 and 3) are drilled
through.
All drill holes should be carefully deburred
and treated with BMW customary corrosion-
protection measures.
In accordance with the given measurements,
mark the centre of the drill hole for cable feed-
through (4) with a marker pen. Lightly centre-
punch the centre of the drill hole for cable feed-
through (4). Make the drill hole for cable feed-
through (4) with a drill Ø 10 mm.
!
Make the aperture (1) for the switch of the roof
headlights (d) in accordance with the diagram
specifications and the following measurements
on the roof console (2).
M1: 23 mm
M2: 160 mm
M3: 43.5 mm
M4: 21.5 mm
Stick the frame for the switch of the roof
headlights (e) in the aperture (1) with
cyanoacrylate adhesive (for verification refer to
BMW parts service, part no. 81 22 9 407 143).
Clip the switch of the roof headlights (d) into the
frame for the switch of the roof headlights (e).
For US market only
For vehicles which are deployed in the US
market, the additional warning sticker (q) must be
fixed on in accordance with the illustration F 53
0168 EVA.This prohibits the use of the auxiliary
headlights on the public highway.
EN/8