BMW Motorrad S 1000RR 2013, Rider'S Manual

Page: 100 / 200

In the gravel trap
with Dynamic Traction Control
(DTC)
OE
DTC deactivation
On very loose surfaces (for
example in a gravel trap of a
race track), DTC's attempts to
control propulsive power might
reduce drive to the extent that
the rear wheel no longer turns.
Under these circumstances,
BMW Motorrad recommends
temporarily deactivating DTC.
Bear in mind that the rear wheel
will spin on the loose surface and
close the throttle in good time
before you reach a firm surface.
Then reactivate DTC.
Removing/installing
mirrors
Removing mirror
Make sure the ground is level
and firm and place the motor-
cycle on its stand.
On each side, remove nuts 1
and remove the mirrors.
Secure fairing 2 to fairing
bracket 3 on left and right.
If cable ties are used, affix
adhesive tape as protection at
the points where chafing might
occur.
NOTICE
Use the HP Race Cover Kit from
BMW Motorrad to cover the
screw holes and restore the se-
cure fastening of the mount.
6
98
z On the race track