WARNING!
In Emergency only!
Use electrical isolator and the gas isolation valve to isolate
the appliance.
Do not use electrical isolator to switch this appliance off in normal use, as the fan
is required to run on to cool the heat exchanger failure to do so will cause damage
to this appliance.
Simple Fault Finding
Some possible reasons for the heater not operating are:
1.
Gas supply not turned ON.
2.
Electrical Supply not turned ON.
3.
The time and/or Thermostats may not be ON.
4.
The Limit stat may have operated due to an interruption of electrical supply
or fault with the distribution fan.
WARNING!
If the limit thermostats persistently operate, there is a fault which must be
investigated by a qualified engineer registered with corgi. This Heater should
not be electrically isolated during normal operation; doing so without a fan
run on for 10 min will cause serious damage to the heater.
Simple Fault Finding (burner faults)
If the burner fails to ignition for any reason, it will go to lockout. This will be
indicated by the red light on the burner or digitally shown on a display screen.
Press in and release the lockout reset button; call a registered engineer if this does
not rectify the problem.
Lockout should not occur during normal operation of the heater and indicates there
is a fault condition which must be corrected.
WARNING!
Do not store or use petrol or other flammable vapours and liquids in the
vicinity of this or any other appliance.
Some objects will catch fire or explode when placed close to the heater.
Failure to follow these instructions can result in death, injury or property
damage
.
42
