Section 19: Users Instructions
WARNING!
If you smell gas:
1. Open all windows and door.
2. DO NOT try to light any appliance.
3. DO NOT use electrical switches.
4. DO NOT use any telephone in your building.
5. Leave the building.
6. Immediately call your local gas supplier after leaving the building; follow
the gas supplier’s instructions
7. If you cannot reach your gas supplier, call the fire department
USERS INSTRUCTIONS
Once the controls have been fully installed and proved with the Heater (all
interlocks proved etc), the supply air has been balanced and only when the Heater
has been fully commissioned by a qualified registered engineer (Corgi), you are
now able to use your Heater safely.
Easy Lighting and Shutting Off Instructions
Burner Start up
1.
Ensure Burner and Heater On/Off Switch is on.
2.
Fan switch is in auto position. If the heater is controlled via a BMS then the
supply fan should be running before the burner can start.
3.
Make sure the time clock and thermostats are calling for heat or that the
BMS is giving enable signal to terminals 1 & 2 in our interface panel.
Burner Shut down
1.
Ensure Burner and Heater On/Off Switch is off.
2.
Fan switch is in auto position. The fans should run on for at least 10 min or
till the fan limit is below 25ºc to cool heat exchanger.
3.
Make sure the time clock and thermostats are not calling for heat or that the
BMS is not giving enable signal to terminals 1 & 2 in our interface panel.
41
