Terminator Salvation™ 42” Fixed Gun Game
Page 43
Terminator Salvation™ Game Software Copyright © 2010 PlayMechanix ™ Inc. All rights reserved.
Coin meter does not click during
Test.
No pulse to meter
Check wiring from meter to RIO
board
Faulty meter
Replace coin meter
Improper number of credits given
when coins or bills are inserted
Incorrect setting in Adjustments
Adjust settings
Faulty wiring
Disconnect cabinet from AC power.
Verify wires are firmly connected to
coin mech and bill validator and
ground wires are properly
connected. Verify no wires are
frayed or shorting to ground.
Faulty coin mech
Verify coin mech is not jammed.
Ensure coin mech is properly
aligned and latched to coin door.
Coin meter does not work
Blown fuse(s) on PCB
Replace 5A fuse(s) on PCB
Exits Test Mode every 3 seconds
Test button stuck in ON position
Slide or toggle button off after Test
Menu appears
NO VIDEO
message
Video cables not plugged in properly Reattach and tighten power and
video cable to monitor.
No Signal
Video or power cable not secure
Check and secure cable.
PC not turned on
Turn PC power switch on. Ensure
IEC cable tightly plugged in. Trace
cable back to source to ensure
continuity.
Dongle Not Present
Dongle missing or disconnected
Find dongle cable and reseat in USB
port
Faulty USB port
Insert dongle cable in different USB
port
Connect RIO Board
or
RIO Board Missing
USB cable disconnected
Check USB connection from PC to
RIO board
No power to RIO board
Check for proper voltage (+5V,
+12V) at JAMMA connector
Watchdog Disabled
or
Watchdog Failed
Watchdog defeated by JAMMA I/O
DIP switch
Set DIP switch 8 to OFF
No power to Reset PCB
Connect power to Reset PCB
Reset input to motherboard
disconnected
Connect 2-pin reset connector from
Reset PCB to motherboard reset pin
input
Violet or black wire from Reset PCB
disconnected or faulty
Check reset wire connection to
JAMMA connector.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
