Terminator Salvation™ 42” Fixed Gun Game
Page 31
Terminator Salvation™ Game Software Copyright © 2010 PlayMechanix ™ Inc. All rights reserved.
2
Remove the two screws shown below from the right side of the gun.
Two Screws on Right Side of Gun
3
Remove the nut that secures the ground wire to the ground lug on the side of the coil assembly
mounting plate, as shown below.
4
Remove the two screws that secure the coil assembly mounting plate to the gun shaft, as shown
below.
Coil Assembly in Gun
5
Reverse the steps to re-install the coin assembly. Be sure to secure the ground wire to the
ground lug on the coil assembly mounting plate.
Gun Pot and Gear Service
Each gun has two pots that measure the movement of the gun on the X-axis (left and right) and Y-axis
(up and down). The X-axis pot is located under the gun base below the trigger. The Y-axis pot is located
on the side of the gun base below the reload button.
Use the Gun Test & Calibrate screen from System Tests in the Operator menu to test gun motion. To test
a pot, power off the game and test resistance at the pot. When you move the gun, you should see a
steady linear increase or decrease in resistance, with no jumps. Replace the gears if they are worn or
cracked.
coil assembly
mounting screws
ground wire to ground lug
NOTE:
You must reconnect this wire.
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
