Service Manual
Maintenance
Terminator Salvation™ Copyright © 2010 T Asset Acquisition Company, LLC
Page 34
Assembled button (left) and disassembled button (right)
Marquee Florescent Light Service
The marquee is lit by a florescent fixture. To gain access to the marquee fixture, remove the three (3)
wood screws and five (5) nuts with washers from the back of the marquee, and then remove the
marquee front with the artwork and clear plastic.
Replace the florescent tube with another 18" florescent tube.
To remove the fixture, disconnect the cabinet from AC power. Disconnect the AC power cord from the
fixture. Remove the two Phillips screws that secure the fixture to the cabinet and remove the fixture.
Cold-Cathode Fluorescent Light Service
The cold-cathode florescent lighting is used to add dramatic lighting effects to the cabinet.
Note: If both lights in a set fail, make sure the power connector is firmly attached to the power inverter.
Connect the lights to another power inverter to test them. Replace the power inverter if faulty; it is held
in place with Velcro and/or cable ties.
Light Location
Size and Qty
Changing Tube(s)
Inverter Location
Kick Panel
One 12” red tube
Remove the four screws
that secure the instruction
panel in place.
Cabinet floor
Area below guns
Two 6” red LEDs; one
below each gun
Beneath gun mounts
Speaker
One 12” tube
Remove the four screws
that secure the instruction
panel in place.
Inside cabinet on side
wall
Marquee
18” traditional
fluorescent
Remove three screws and
five nuts with washers, then
the marquee front
lamp
connector
switch
actuator
NO signal wire
COM signal wire
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
