Terminator Salvation™ 42” Fixed Gun Game
Page 33
Terminator Salvation™ Game Software Copyright © 2010 PlayMechanix ™ Inc. All rights reserved.
Gun Driver Board
Start Button Service
The Start buttons for each player are illuminated with 12-volt lamps. Perform the following steps to
replace the buttons, lamps, and micro switches:
1
Disconnect the cabinet from AC power.
2
Open the coin door and reach up under the control panel to access the buttons.
3
To remove a micro switch, gently rock it to the side and remove it from the housing. Remove the
wires and install them on the same connectors on the new micro switch.
4
To remove the lamp housing, gently rock the white plastic housing from side to side to pop it
out of the button housing.
5
To remove the button from the control panel, unscrew the retaining ring from under the control
panel.
6
To remove a lamp from the housing for replacement, pull it straight out of the lamp housing.
7
When connecting the wiring to the micro switch and lamp, refer to the labels on the wires and
the image below to make sure the connections are correct.
MICROSWITCH CONNECTION
Do not connect the 12-volt lamp power wire to the micro switch. This could damage the BVRI/O PCB.
8
Reverse these steps to install the replacement button and micro switch. Connect the ground
wire to the COM connector on the bottom of the switch housing, and the signal
To Purchase This Item, Visit BMI Gaming | www.bmigaming.com | (800) 746-2255 | +1.561.391.7200
