bmb-home HOME PROTECTOR+, User Manual, Page: 14 / 32

P/N 033000=13610 Rev. 01-02-06 BMB Home Security
14
4.2 Motion Detector MS18
1.
Control Indicator - Lights up when a signal is transmitted.
2. PIR
3. Tamper contact .
4. Battery compartment .
5. Sensitivity switch 1/2 - In setting 1 the sensor will instantly react to movement, in setting 2 the sensor is less
sensitive and will only react after registering multiple movements.
6.
TEST button .
4.2.1 Mounting the Motion Detector MS18
The motion detector works by detecting changes in temperature. Do not
mount the detector too close to a heater or air conditioner.
The motion detector has a range of 12m and an angle of 90°. Because of
the special lens the sensor ‘looks down’. Always mount the MS18 at a
height of about 180 cm from the floor and place it in such a way that the
detector can cover the area you want to secure. The mounting bracket
can be placed at an angle (90°) or directly against the wall.
4.2.2 Using the Motion Detector
1. Open the battery compartment and insert the batteries (2xAA, alkaline).
2. Keep the TEST button (6) pressed for about 4 seconds. The LED will
flash once. Release the button. The LED will flash twice. The motion
detector has now chosen a unique code, which can be registered with your console. Place the motion detector
upside down so that it can’t detect any movement during registration.
Test mode: Testing the location of your motion detector
1. Set the switch (5) to 1.
2. Press the TEST button (6) until the indicator (1) flashes twice.
3. Wait 20-30 seconds.
4. Walk in front of the sensor. The indicator (1) lets you know when a movement has been detected. This allows
you to check whether the sensor has been mounted on the right place.
5. Press the TEST button again to be able to use the sensor as normal.
After 2 minutes the motion detector will go back to the normal mode.
4.2.3 Registering a Motion Detector with the Console
1. To access the menu, press the menu UP ? or menu DOWN ? button. The display now shows
ENTER PIN
.
2. Enter your 4-digit PIN code (factory setting 0000. See 8.3 for changing the PIN code). The display is cleared
and shows a * for each number entered.
3. When the PIN code has been entered correctly, the word
INSTALL
will show up on the display.
4. Press OK. The display will read
INSTALL ZONE
.
5. Press the TEST button of the motion detector or turn it around, so that the sensor will detect movement. The
console will beep to confirm. The display will read
ZONE …’. SET
.
A memory space for a sensor is called a zone. If you have more than 1 sensor installed, it will show e.g.
ZONE 2
SET, ZONE 3 SET, … ZONE 30 SET
.
You can choose in which zone you want to install the sensor. If you want to install the sensor in zone 3, press 3
on the number pad before executing step 5.
1
2
3
4
5
6