8
9
NDY-19MA-E
NDY-19MA-E
In
more
detail
. . .
Getting
Started . . .
6. Repeat this for the other side of the appliance, so that you have 1 bracket on the
left and on the right of the appliance.
7. Carefully place the appliance on the wall and mark the holes of the brackets on
either side.
8. Using a 8 mm diameter drill bit, drill two 40 mm deep holes where the two markings
are, and place the wall plugs (A) in the holes.
9. Place the fireplace aligning the two holes with the brackets, and use 2 screws (B)
to fix the fireplace to the wall.
10. The fireplace must be secure so that it is not possible to pull away using normal loads.
11. WARNING: This product is heavy. Failure to install this product securely and in
accordance with these instructions could lead to a serious or fatal injury!
[A]
4
2
3
[C]
[D]
[01]
1
01
[B]
02
The controls
Switching on/off
Use the on/off switch to power on the appliance (set it to standby mode).
In standby mode, the appliance can be operated either manually, by the switches located
on the front bottom left hand side of the appliance or by the supplied remote control.
Manual control
NOTE:
The appliance only starts working, if the set temperature is higher than
the ambient room temperature.
Appliance powered off
Appliance powered on, set to standby mode
> Press to switch the flame effect on/off.
> Press and hold to toggle between 5 different flame
dim levels
Press to activate low level heating (1000 W)
Press to activate high level heating (2000 W)
Installation
Operation
[C] x 4
[D] x 2
[01] x 1
[B] x 2
[A] x 2