IP250UHD
USER MANUAL
Contact:
|
|
25
The Blustream Multicast Receiver has an in-built video scaler which can both up-scale and downscale video signals
allowing for differing image resolutions at each display.
Configuration of Multicast Scaler settings can be achieved in several ways:
1)
During the manual configuration of the IP250UHD-RX Receiver - see previous pages
2)
Using the Multicast web-GUI interface (by addressing the unit via it's IP Address within a browser)
3)
Using the web-GUI of the Blustream ACM200
4)
Using IP / RS-232 commands via the Blustream ACM200
When configuring the Scaled output during manual setup, or using RS-232 commands, the following table indicates
Scaler settings.
Scaler Output Control
SCALER
MULTICAST RECEIVER SCALER SETTINGS
00
Pass Through - allows native source resolution to pass-through to display * (default setting)
01
HDMI 1080p@50Hz
02
HDMI 1080p@60Hz
03
HDMI 720p@60Hz
04
HDMI 720p@50Hz
05
HDMI 1280x1024@60Hz
06
HDMI 1024x768@60Hz
07
HDMI 1360x768@60Hz
08
HDMI 1440x900@60Hz
09
HDMI 1680x1050@60Hz
10
HDMI 2160p@30Hz
11
HDMI 2160p@24Hz
Please note:
the maximum output resolution of the IP250UHD-RX is 4K @ 30Hz. Where a source resolution is equal
to 4K @ 50Hz or 60Hz, the output resolution is automatically scaled to 4K @ 25Hz or 30Hz (half the value of the input
frame rate) when the scaler output is left as 'Pass Through'.
It is recommended to try as best as possible to match frame rates throughout the system to reduce the potential of
juddery images.
Display settings can also negatively affect motion on an output image from an IP250UHD-RX. Settings such as 'Motion
Smoothing' should be turned off to avoid this issue. Alternatively, setting the display to 'Game Mode' will turn off all
additional processing within a display.
