IP250UHD
USER MANUAL
www.blustream.com.au
|
www.blustream-us.com
|
www.blustream.co.uk
20
The Blustream Multicast system can be configured without the need of a computer, allowing basic setup options such
as addressing of products (IP configuration), EDID selection (TX), and Scaler output selection (RX).
Manual configuration does not require the product to be connected to a network switch in order to be set-up, it only
requires the unit to be powered either by local power supply (24V 1A) or by a PoE switch/injector. This means total
configuration can easily be achieved offsite without any network hardware in place.
Please note:
Advanced features such as video wall creation cannot be setup via manual configuration, and requires
the ACM200 web-GUI.
Manually configuring an IP250UHD-TX:
1) Power the IP250UHD Transmitter
- to configure the Multicast Transmitter first connect the product to a power
supply (local or PoE network) and wait for the product to boot-up. The front panel will display 'Boot up' whilst booting
and display the TX Name when complete. This will be 'Source000' if the unit has default settings.
2) Put the IP250UHD-TX into 'Manual Configuration' mode
- once the product is powered press both the 'UP' and
'DOWN' channel buttons on the front panel at the same time for 5 seconds to enter 'Manual Configuration' mode.
The front display of the product will show 'Manual Configuration' when it is in this mode. Release both buttons when
'Manual Configuration' is displayed.
3) Assign the Transmitter ID (IP address)
- once the product is in Manual Configuration mode the display will begin
to show 'Choose TX No.' to indicate the assigning of the transmitters identity. The identity number will also be the IP
address that is automatically assigned, so is of utmost importance that an individual ID is not equal to another TX unit
in the system that has already been assigned:
- The first ID that should be assigned is ID001 = 169.254.3.1 (IP address 1)
- The second ID that should be assigned is ID002 = 169.254.3.2 (IP address 2)
and so on....
Once the TX ID number has been selected and is correct, confirm the selection by pressing both Channel 'UP' and
'DOWN' buttons at the same time to move on to setting the EDID.
4) Set the EDID
- once the product is in EDID configuration mode the display will show 'Set TX EDID' to indicate
that the assigning of an EDID value is about to commence. Use the 'UP' or 'DOWN' arrows to select the EDID setting
required. The EDID format (resolution and audio format) will be shown on the display. A full list of EDID settings can be
found on the 'EDID Control' page.
Once the required EDID has been selected, press both Channel 'UP' and 'DOWN' buttons together to finalise the
manual configuration process.
"Applying Configuration" will be shown on the display and then
the Multicast Transmitter will reboot with the new
settings applied.
Manual Configuration of Multicast Products
