IP250UHD
USER MANUAL
Contact:
|
|
21
Manually configuring the IP250UHD-RX:
1) Power the IP250UHD Receiver
- to configure the Multicast Receiver first connect the product to a power supply
(local or PoE network) and wait for the product to boot-up. The front panel will display 'Boot up' whilst booting and
display a the RX Name when complete. This will be 'Receiver000' if the unit has default settings.
2) Put the IP250UHD-RX into 'Manual Configuration' mode
- once the product is powered press both the 'UP' and
'DOWN' channel buttons on the front panel at the same time for 5 seconds to enter 'Manual Configuration' mode. The
LCD front display of the product will show 'Manual Configuration' when it is in this mode. Release both buttons when
'Manual Configuration' is displayed.
3) Assign the Receiver ID (IP address)
- once the product is in Manual Configuration mode the display will show
'Choose RX No.' to indicate the receiver identity number that is going to be assigned. The identity number will also be
the IP address that is automatically assigned, so is of utmost importance that an individual ID not equal to another RX
unit in the system that has already been assigned:
- The first Receiver ID assigned is ID001 = 169.254.6.1 (IP address 1)
- The second Receiver ID assigned is ID002 = 169.254.6.2 (IP address 2)
and so on....
Once the ID number has been selected and is correct, confirm the selection by pressing both Channel 'UP' and 'DOWN'
buttons at the same time to move on to setting the scaled output.
4) Set the Video Scaler of the Receiver
- once the product ID has been configured the display will show 'Set Scaler
Res' to indicate that the scaler output is next to be configured. Use the 'UP' or 'DOWN' arrows to select the scaler
setting required. The scaler resolution will be shown on the display. A full list of scaler settings can be found on the
'Scaler Output Control' page.
Once the scaler value required has been selected, press both Channel 'UP' and 'DOWN' buttons to finalise the manual
configuration process.
"Applying Configuration" will be shown on the display and then
the Multicast Receiver will reboot with the new settings
applied.
