8
EN
Install the slide rail set. Then, install the rear
joint and the Stopper into the slide rail set. Use
the 5 mm and
6 mm type Allen wrenches, 2 M8”2O semi-cir-
cular hexagon socket head cap screws, 2
curved washers, and
1 M8*35 hexagon socket head cap screw to se-
cure the slide rail set (As shown in Figure D, but
do not lock screws). Repeat for the other side.
Load the cushion into the slide rails. (As shown
in Figure E)
To install the foot pedals, locate the two brac-
kets on the inside of the rails.
Insert the sides of the foot pedals’ connected
bar into the brackets (As shown in Figure G).
Install the rear support and stopper into the
slide rail set. Use the 5 mm, 6.mm type hex
wrench, 2 M8*20 semi-circular hexagon socket
head cap screws, 2 curved washers, and l
M8*35 hexagon socket head cap screw to lock
the Rear Support. Finally, lock all the screws (As
shown in Figure F).
Once the foot pedals’ have been placed into
the brackets, use the provided Locking Pins
to secure the foot pedals in place. Locate the
opening in the bracket that aligns with the hole
in the side of the foot pedals’ bar. Insert the
Locking Pin all the way through (As shown in
Figure H). Repeat for the other side.
D
E
G
F
H
FOOT PEDAL ASSEMBLY
2021-07-22 OCG BluMill Rowing Machine ManualV02.indd 8
2021-07-22 OCG BluMill Rowing Machine ManualV02.indd 8
29-07-2021 08:32
29-07-2021 08:32
