23
BA-102/2EN M54.XXXX
7.1 - General
7 - drilling heads
7.1.1) Attaching drilling heads
• Attach drilling head holder to a wall, table or the storage rack.
The storage rack is available from Blum as an accessory. (MZA.2600)
IMPORTANT:
The total length of the drill bits (from bit-tip to adjustment screw) should
be x = 57 mm.
7.1.2) Setting drill bit length
Adjustment:
• Set length by turning the drill bit adjustment screw using a screwdriver.
7.1.4) Attaching insertion ram to the swing arm
• Place insertion ram onto the two fixing screws
(7.1)
on the swing arm
• Tighten the fixing screws
(7.1)
so that the insertion ram is secure
Setting insertion ram position:
• Loosen fixing screws
(7.1)
• Correct the position of the insertion ram by setting the adjustment screws
(7.2)
• Loosely retighten fixing screws
(7.1)
7.1.3) Inserting drill bits into the chuck
ATTENTION:
Before changing drill bits, remove the drilling head from the machine.
• Loosen the fixing screw using a hex wrench.
• Push drill bits into the chuck (The surface of the drill shaft must be placed in the
direction of the fixing screw)
• Retighten fixing screw
IMPORTANT:
Insert cover caps into the unused bits. This will keep the bits clean and
prevent the fixing screws from coming out on their own.
7.1
7.2
!
!