EN7
if the WateR PuRifieR is nOt WORking
tROuble-shOOting table
To protect the user and the water purifier from incorrect use,
there are built-in alarms which cause the purifier to give an
indication and stop. The table below gives probable causes of
warnings given by the water purifier.
extinguished
flashing
lit
symPtOm
check/Remedial actiOn
ON light not lit.
The water purifier is not receiving power.
- Is the plug connected?
Yellow light on the faucet flashing and filter light
flashing.
Indicates that it is time for filter replacement.
- Change filter in accordance with «Replacing the filter».
Yellow light on the faucet flashing and filter light
lit.
Emergency stop due to filter not having been replaced.
- Change filter in accordance with «Replacing the filter».
Yellow light on the faucet flashing and service
light flashing.
Indication of deterioration in water quality.
- Contact your dealer for membrane replacement.
Yellow light on the faucet flashing and service
light lit.
Emergency stop due to air in the system caused by filter
replacement.
- Pull out the plug and connect it again. Let the purifier go
throug the flush before starting production of pure water
.
Emergency stop due to deterioration in water quality.
- Contact your dealer for membrane replacement.
Yellow and Green light on the faucet lit and serv-
ice light lit.
The water quality measurement is not working.
- Contact your dealer for replacement.
Noise from the water purifier.
The water purifier is not receiving sufficient water.
- Is the inlet pressure lower than 1.5 bar during operation?
- Is the grid blocked? — Clean the grid.
- Is the filter blocked? — Change filter.
Motor not starting.
Yellow or green light on the faucet lit.
The overflow protection has been triggered.
- Pull out the plug and wipe clean the base plate.
- If it is triggered again, call your dealer.
Motor not starting.
The water purifier is flushing.
- Wait for 5 minutes.
- Is the faucet cord connected?
low flow from the faucet.
- Is the membrane blocked?
- Descale the water purifier in accordance with «Descaling».
- Make sure the pure water hose is not jammed.
No flow from the faucet.
- Is the shut-off valve for the feed water open?
Dripping from the faucet during flushing.
The hight distance between the faucet and the water puri-
fier is less than 500 mm.
- See «Installation».
Unpleasant smell.
Odour problems can be caused by micro-organisms in the
water because the water purifier has not been used for an
extended period (1 week or longer).
- Clean the water purifier in accordance with «Disinfection».
If you are still having problems with your water purifier after having read through and tried the procedures described in the
trouble-shooting table, please contact your dealer.
Summary of Contents for Spirit RO 300
