BlueTree BT4400, Product Manual

Page: 30 / 38

Chapter 4: Installing the Modem
30 BlueTree Wireless BT4400 & BT5400 Product Manual V0.0
2.
Connect the other end of the ethernet connection of your terminal.
Connecting the USB cable:
This feature is not supported on product version 1.0
8) Configuring the
modem
Once the physical installation is complete, the modem should be
configured for:
•
Activation on the wireless network
• Operation mode and network connection setup
This configuration is peformed using:
•
BlueVue Device Manager companion software, or
• through standard AT commands (refer to AT Command manual).
9) Connecting to
the wireless
network using the
serial port (DB9)
Note: The following section is only required if you want to connect to the
network using a PC/laptop with Windows 2000/XP. It is described here as an
example of how a connection profile should be configured to work with the
BT4400/5400 modems.
Adding the modem To add a modem in Windows 2000 or XP
1.
Click Start > Settings > Control Panel > Phone and Modem Options.
2.
On the Phone and Modem Options box, click the Modems tab and
then:
a) Click Add .
b) Check the box labelled “ Don’t detect my modem; ...” and
then click Next .
c) Select the Standard 33600 bps Modem and click Next.
d) Select the COM port that the modem is attached to then click
Next .
e) Click Finish to complete the addition of the modem in
Windows.
f) Click the Modem tab and confirm that the Maximum Port
Speed is set to 115,200.
g) Click OK .
The modem profile is now configured.