BlueLine VORTEX 7000HHP, Manual

Page: 23 / 86

SECTION 2
BLUE LINE VORTEX 7000HHP 19
JET SIZING
BLUE
LINE recommends that the total floor
tool size does not exceed “.06”. Using larger
jet sizes on your
VORTEX mobile cleaning
unit may reduce cleaning temperatures.
Example: Four–jet wand uses four 95015 jets.
(95 deg. Spray angle w/015 orifice)
. 015 x 4 = .06
When using two wands while cleaning with
this unit,
BLUE LINE recommends that the tip
size in each tool does not exceed a total of
“.04”.
Example: Four jet wand uses four 9501 jets.
(95 deg. Spray angle w/01 orifice)
.01 x 4 = .04 x 2 tools = .08
Upholstery tool jet size: 80015.
Stair tool jet size: 9502
STARTING THE UNIT
!
Operate this unit and equipment only in a
well ventilated area. Exhaust fumes contain
carbon monoxide, which is an odorless and
deadly poison that can cause severe injury
or death. DO NOT run this unit in an
enclosed area. DO NOT operate this unit
where the exhaust may enter a building
doorway, window, vent or any other
opening.
1. With the truck running at idle
(approximately 700 RPM) pull the main
power switch to energize the control panel.
2. Push the
“ENGAGE PTO” switch. in, to
engage the PTO. The blower pulley will start
turning. Allow approximately 30 seconds for
the mobile cleaning unit to stabilize at idle
speed.
NOTE: Engage PTO with engine at idle
speed.
3. Set the oil temperature gauge to the desired
cleaning temperature. Press the red button
located on the lower left of the oil temperature
gauge. Turn the knob located on the right of
the gauge to set the temperature. Turn
clockwise to increase, counter-clockwise to
decrease. When the button is pushed in and
held it displays the oil set temperature. When
it is released it displays the oil temperature.
!
The temperature set point can be changed
without displaying the set point. Do not
turn the set point control knob unless you
want to change the temperature set point.
The thermostatic control is designed to
maintain the solution temperature
automatically.
4. To engage the water and oil pump, pull out
the
“ENGAGE PUMP” switch. Allow
approximately 30 seconds for the engine to
once again stabilize its idle speed. The water
pump will circulate water through the pressure
regulator, the engine coolant heat exchanger,
the vacuum exhaust heat exchanger and back
into the fresh water tank. The oil pump will
circulate the heat transfer fluid between the
upper and lower xentherm heat exchangers.