BlueCreation
.
St John’s Innovation Centre Cowley
Road Cambridge CB4 0WS United Kingdom
t
.
+44 (0)1223 420 252
e
.
www.blue-creation.com
BC111-DISKIT-001
Manual
If the device has not enumerated as a COM port, then you need to re-install the driver. This is done by going
to Properties/Change Settings/Update Driver as in the figure below. You can also try Properties/Change
Settings/Un-install. When you plug the board back in, the PC will look on Internet for the drivers.
If the FTDI driver still does not work, you might want to erase all registers. this can be done by following the
instructions below. Source: http://forums.parallax.com/showthread.php/139524-FTDI-Driver-problems-with-
Windows-7-64-bit-(Also-uninstalling-drivers-COM-entries):
Step1) If you need to clean a previous install of the FTDI driver from your system and/or clear any COM Ports
added to the registry then you should obtain the CDM Uninstaller from the following link:
http://www.ftdichip.com/Support/Util...aller_v1.4.zip
Extract the contents of this ZIP file into a folder on your desktop or elsewhere and run the
CDMuninstallerGUI.exe file.
