Blueair BLMI-300A, Installation And User Manual

Page: 11 / 36

10
11
2. Installation & Operation Guide
2.2 Installation Requirements
The installation location of the ice machine should satisfy following conditions.
If the location does not satisfy these conditions, do not install the machines in that location.
The installment location must be changed to meet following conditions.
- The location should be in indoors and have good ventilation
- The location should not be near a heat source and should not be in direct sunlight
- The operating temperature at the location should be between 45°F- 100°F(7°C- 38°C).
- The location should have access to a water supply, drainage and an easily connected
source of electricity
- The location should not have any obstacles, disturbing air circulation(heat exchange)
- The location should have enough clearance for wiring and plumbing on the rear.
- The location should have no food waste nor food contaminant.
- The location should support the full weight of the machine filled with ice.
- The head and bin should be level.
- The vent of the of ice machine and drain of the bin should be separated.
- The drain tip of the bin should have an air gap.
- The ice machine and bin should be completely cleaned after installation.
- The drain line should be easily separated from the ice machine.
- There must be minimum of (8 inches (20 cm) )of clearance, around, above and below the
machine for enough air circulation and maintenance.
- Carefully align the ice machine with the bin to ensure a secure seal.
WARNING
- The ice machine should be installed, following the local regulations of the country, state and region.
- Read the manual thoroughly before installation. Incorrect installation may cause
malfunction, or bodily injury and death.
- Do not drop tools into the bin or the floor of the unit during installation. It may cause
injure during routine operation of the machine.
- Do not operate unit with enclosure removed. This is marked by a sticker labelled "CAUTION
or WARNING - Parts. Do Not Operate Unit With Enclosure Removed."
(When disassembly for cleaning or similar servicing exposes moving parts.)
2.1 Location Requirements