20
21
2.11 Test Run
WARNING
The Ice machine is factory-adjusted. In general, no additional setting is required after installing the
product. In cases of random modification, it may cause adverse influence on safety, function,
component lifespan, and warranty period.
WARNING
After installation, make sure that all components, fixture, and thumbscrews are securely
connected Ensure that no impurities have fallen into the ice storage bin.
1. Open shut-off valve of water-supply line.
2. Turn on the ice machine by pushing “POWER” button and operate it for 10 minutes.
3. Turn off the power and remove the front panel.
4. Drain the remaining water inside of the tank after removing Ice cover and disconnecting the ‘
ㄷ
’ shape hose
that connects the Water tank and Pump motor.
5. After drainage, reattach hose.
6. With a neutral detergent, clean the inside of the ice storage bin.
7. Re-assemble ice cover and the front panel.
8. Turn on the ice machine again.
9. Check if the bin switch works by pushing flap of the bin switch within first 5 minutes of freezing cycle.
10. Continue Pressing flap of the bin switch for 10 seconds.
11. The ice machine will stop operation with ‘Full’ display. After 5 seconds you should stop pressing the flap of
the bin switch, ‘Full’ will be disappeared and the ice machine goes into the water supply procedure. (The ice
machine will stop operation immediately if you press flap for 10 seconds within 5 minutes after initiating
ice making cycle. If not, the ice machine will stop after completion of ice making and harvest cycle.)
(1) Is ambient temperature of the installation area within the appropriate temperature range of
45-100°F(7-37°C)?
(2) Is water temperature supplied to the installation area within the appropriate temperature range of 45-90°F
(7-32°C)?
(3) Are all the packing materials such as the packing box, inside tape, and other materials removed
completely?
(4) Is there enoughclearance (min. 8 inches)above, below and around the ice machine for smooth air
circulation?
(5) Is the ice scoop placed in the right place?
(6) Is the ice machine level on the floor?
(7) Is the product located indoors?
(8) Is the power supply to the ice machine installed properly?
(9) Is the water supply pipe to the product properly connected?
(10)Is drain system properly connected?
(11)Is water pressure between 30 ~ 100 psig (206.8-689.4 kPa)?
(12)Are there any leakages found in any pipes?
(13)Are all the components, fixtures, and thumbscrews secure?
(14) Have you informed customers about the product manual, how to operate the machine, and when to
replace parts?
(15)Have you informed the customer how to get service if the unit has a problem?
2.10 Final Check
Summary of Contents for BLMI-300A
