7
TWO SPEED OPERATION
DUAL PORT INSTALLATION
• The pump speed is controlled by the rocker switch located at the rear of the motor.
• The low speed setting should be used for normal operation. The motor should be operated at this
slower speed to help save energy during normal pool filtration.
• The high speed setting should be used when operating additional equipment with your filtration
system such as a vacuum.
• To manually change the speed from low to high simply change the position of the rocker switch at
the rear of the motor. See the image below.
• To manually change from high to low speed simply change the position of the rocker switch at the
rear of the motor. See the image below.
• Your pump is equipped with a dual port pump housing.
• This means you can utilize a vertical or horizontal discharge for your pump. If you have a sand filter
tank, the vertical discharge works best.
A
• To use the vertical discharge, you need to install the restrictor cap on the horizontal port —
See
Diagram A
.
NOTICE
THE MOTOR WILL ONLY RUN AT THE SPEED SELECTED BY THE ROCKER
SWITCH AT THE REAR OF MOTOR.
