an area protected from freezing. The solar heater should be removed before the first frost, or at the end of
the pool season.
All parts must be rinsed or cleaned with water only. Detergents may damage the protective cover.
6. Storage
Drain all the water from the solar heater by closing off the pipes. Store the solar heater for Winter in an area
protected from freezing. Remove the pool return pipes.
Make sure there is no water left inside the solar collector as it can freeze. Freezing water can damage the
solar chambers.
C. Technical data
NS1002 FX Flat Panel Solar Heater - 21'Pool
Dimensions: L x W x H 37.8"x 29.53"x18.50" (96x75x47cm)
Maximum pressure 14.5psi/1 bar at 68
℉
(20
℃
)
Water flow rate max. 1980GPH (7500LPH)
Water capacity 3.2gal (12l )
D. Unpacking Your Solar Heater
Carefully remove the product and all component parts from the box. Make certain all
parts are present before beginning assembly.
Refer to section I for a complete PARTS BREAKDOWN.
E. Installation instructions
1.Assembly instructions
Before you begin installation of the solar heater turn off the filter pump and close off all water connections.
Unfold the feet at the bottom and adjust position according to the sun. Make sure to obtain a 30°
inclination.
Fit the 2 hose connectors (4) with the connector caps (5) on either side of the solar heater.
A. Pools with 1¼” or 1½’’ Diameter Unthreaded Hoses
Connect the hoses (8+9) between the filter unit, the solar heater and the pool.
Assembly with a 1¼” (32mm) hose connector.
This has to be pushed directly over the hose connector (4) and fastened with the hose clamp (7) .
Assembly with a 1½’’ (38mm) hose connector.
First push the hose reducer (6) 1¼”-1½’’ (32mm/38mm) over the hose connector. Then push the 1½“
(38mm) hose over the hose reducer (6) and fasten it with a hose clamp (7) .
B.Pools with 40mm Diameter Intex® Threaded Hoses
Attach the adapter for either Intex® (#10,11&12, Included in the product you purchased) or Bestway
(Not included) to the hose connectors (4). Make sure the o-ring is in the collared tube adapter prior to
attachment.
Screw existing threaded 40mm Intex® pool hoses onto the adapters. Be sure to place the thick connec-
tor gasket between the hose and the adapter for a tight seal.
2
