A.Safety instructions
Read through these instructions carefully before you use the product.
Caution: Failure to comply fully with our instructions for use, or safety instructions, may cause
damage or injury to individuals.
Please read the instruction manual and the directions shown there.
Do not allow children to handle the solar collector.
Always turn off your filter system when you are working with your solar heater.
Do not position the solar heater too close to the pool (adequate safe distance).
Do not use any petroleum-based lubricants. Petroleum attacks the product’s plastic components.
This solar heater is not intended for use by anyone (including children) with restricted physical, sensory
or mental ability, or with limited experience and / or limited knowledge, unless they are supervised by
someone responsible for their safety, or they receive instruction from them regarding the use of the solar
heater.
Children must be supervised to ensure they do not play with the solar heater.
B. General information
1. Conditions for the installation of the solar heater
The solar heater you have purchased is intended for use with in-ground and above-ground pools, and is
easy to install and handle. These installation instructions are based on the following conditions:
1) You have a pool which is fully built and filled with water.
2) Your pool has a filter system.
3) You have the required connector & hoses Ø 1.25”-1.5”(Ø 32/38 mm) to supply the pool and filter system
with water.
4) You are not installing the solar heater under trees.
These are the requirements so that the solar heater can force water through the solar chambers when it is
installed and fully connected to the filter pump.
2. Use
（
Figure 1
）
Once the solar heater is installed, it is connected between your filter system and your pool using the two
hose connectors.
The water is heated by the sun’s energy and then fed back through connector hose to the pool.
A = feed from the filter unit to the solar heater
B = feed from the solar heater to the swimming pool inlet nozzles
Water heating depends on the following factors: flow rate and intensity of sunshine.
Solar heating only functions efficiently in sunshine. The solar heater can remain connected to the pump in
poor weather or at night as this only causes a slight loss of pressure in the pump.
3. Tools and accessories required
Tools required for assembly, but are not included in your set:
Phillips screwdriver
Flat head screwdriver
4. The ideal location for your solar heater
Your solar heater needs to be in a location with as much sunshine as possible.
Never position the solar heater over the surface of your pool.
The solar heater is designed to allow maximum possible capture of sunshine.
5. Product care
The solar heater should not be left connected in extreme cold weather. The solar heater should be stored in
1
