Operation
9
Open Burners
NOTE: Only Cooking Pans Ø120mm to Ø380mm are suitable for use on open burners.
Lighting the Open Burners
Flame Failure Protection is incorporated for each burner by way of a thermo-electric system which will shut off gas
supply to that burner in the event that the burner goes out, so that un-burnt gas is not expelled.
1.
Ensure the mains gas supply is turned ‘On’.
2.
Select burner required, turn the gas control knob anti-clockwise to ‘HIGH’ position.
3.
Hold gas control knob depressed and manually light the main burner.
4.
Release gas control knob after approximately 10-20 seconds after lighting burner.
5.
Burner should stay alight - if not, repeat Steps (2. to (4. above.
6.
To adjust the temperature required, rotate gas control knob between ‘HIGH’ and ‘LOW’ positions.
Turning 'OFF' the Open Burners
1.
When main burner is not required, turn gas control knob clockwise back to the ‘OFF’ position, burner will
extinguish.
Oven
Lighting the Oven Burner
1.
Ensure the mains gas supply is turned ‘On’.
2.
Open Oven doors.
3.
Rotate thermostat control knob to the maximum temperature marked on the knob and hold knob depressed.
4.
Press the Piezo Ignition Button on the control panel.
5.
Release gas control knob after approximately 10-20 seconds after lighting burner.
6.
Oven Burner should stay alight - if not, repeat Steps (3. to (5. above.
7.
To adjust the temperature required, rotate oven gas control knob to the temperature required.
Turning 'OFF' the Oven Burner
1.
When oven burner is not required, turn oven temperature control knob fully clockwise to the ‘OFF’ position,
burner will extinguish.
C
ARE
IS
REQUIRED
WHEN
OPENING
HOT
OVEN
DOOR
TO
AVOID
EXPOSURE
TO
HOT
OVEN
AIR
AND
VAPOURS
.
Warning
Summary of Contents for G750-6
Page 6: ...Dimensions 4 G750 6 ...
Page 20: ......
