Blue Seal Evolution GE505, Operation Manual

Page: 30 / 37

28
Gas Conversion and Specifications
Pilot Injectors
a. Unscrew and remove the Pilot Injector Plug from the
fitting at the end of the pilot injector tube using a 11mm
A/F spanner. (see Fig 23).
b. Using a flat bladed screwdriver, unscrew and remove the
pilot injector from the pilot injector housing.
NOTE Take care not to lose the spring fitted in front of the
injector.
c. Remove existing pilot injector and replace with the
correct size pilot injector for the gas type being used.
Refer to the ‘Gas Specifications’ table at the end of this
section, for correct pilot injector sizes.
d. Refit the spring and the correct pilot injector to the pilot
injector housing.
e. Screw the pilot injector fully home using a flat blade
screwdriver and refit the pilot injector plug to the pilot
injector housing and tighten in place using a 11mm A/F
spanner. (See Fig 23).
f. Refit the splash guard over the gas cocks taking care not
to damage the thermocouples and pilot burner tubes.
S ecure in position with the 2 allan headed screws. (Note
that the splash guard for 'PF' models has a different
cut-outs for pilot burner tubes. See Fig 24 & Fig 25).
g. Refit the pilot burner tube shields over the pilot burner
tubes / thermocouples and secure in place with the 2
securing screws. (See Fig 21).
h. Refit the burner caps and burner bowls onto the
manifolds protruding through the splash guards. Take
note that the base part of the burner bowl has 2 locating
holes drilled into the base flange, (See Fig 17). these are
to locate the burner bowl onto the allen headed screws
that secure the splash guard to the gas manifold. (See
Fig 15).
i. Refit all the trivet supports to the top of the appliance.
Note the orientation of the trivet support when re-fitting
as the front end side rail profiles are different from the
rear end side rail profiles. (See Fig 14).
j. Refit the trivets to the top of the appliance taking note
that the trivets are manufactured with a lip on one edge,
the lip must always be fitted to the outer edge (front and
back) of the cook top. (see Fig 18).
Low Fire Adjustment
a. To adjust the open burner low fire adjustment, remove
the gas control knobs from the front of the control panel.
b. Adjust the low fire adjustment screw on the open burner
gas control valves to obtain the desired flame size.
( Refer to Fig 26).
NOTE: The ‘Low Fire Screw’ should be sealed with coloured paint on completion of the low fire
adjustment.
Pilot Injector
Plug
Pilot Injector
Housing
Low Fire Adjustment Screw
Fig 26
Fig 23
Fig 24
Cut-Out for Pilot
Burner &
Thermocouple
Fig 25
Shown without Pilot
Burner Shield fitted.
Pilot Burner
Thermocouple